ClearCom KB-212 Manuel d'instructions télécharger pdf (Page 38)

RS-601 BELPACK

To rotate the beltclip to a new position:

1. Remove the setup help label and the two retaining screws.

2. Rotate the beltclip 90

or 180

as desired.

3. Replace the screws.

The label on the beltclip is not reusable and must be replaced. You

can order a replacement label from your distributor or from the

factory.

Use the same procedure for replacing a broken or damaged beltclip.

CLEANING

To clean the surface of your beltpack, use a damp cloth and mild soap.

Remove all soap residue and excess moisture before returning to

service.

TROUBLESHOOTING

PROBLEM

Low audio level.

CAUSE

Multiple terminations on the line. Excessive

capacitance and/or resistance due to cable

length and/or gauge.

SOLUTION

If connected to more than one main station

or power supply, check that there is only

one termination per channel.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Pas de commentaire

ClearCom KB-212 Manuel d'instructions Page 38